Brass Stencils

7 posts / 0 new
Last post
goldiewing1
Brass Stencils

I am a brand new owner of a shiny new Emboss.

Can I use brass stencils, and is that what the rubber sheet is for?

If not, what is the rubber sheet for?

Thanks

Shirli

goldiewing

Ok, had my Embosser a few days, and have solved the conundrum I had in my previous posting.

If you have any brass stencils ( which I did), use this platform to emboss.

D > Shim(E) > C < rubber mat > sheet card or paper > A

Hope it helps someone along the way.

Goldiewing.

eboyd

I would like to see platforms for the long Sizzix dies. I am getting rid of Cuttlebug as my hands are wearing out but will keep the Big shot until ebosser can cut the longer dies.

eboyd

That doesn't sound like enough plates. I have a lot of stencils to use.

TeamCraftwell

Hello everyone,

The plates are in a shipment and should be in stock by the Holidays. Because of Hurricane Sandy and the recent snow storm, our shipping has been delayed. Thank you for understanding.

Team Craftwell

suesoutham

I have just got my machine and did first run with the free embossing folder and everything was fine. Second run was with M-Bossabilities Folder and the machine stopped (think it did not like the plate combination. I removed the plates as they were not jammed. Now the machine will not work at all. Turned it off and left overnight and it still will not work.

eboyd

Talk to customer service thety are good about helping.